Product Introduction: CR-prefixed parts in Kollmorgen's cable catalog are pre-manufactured interconnection cables for AKM servomotors — either power-only, feedback-only, or combo. CR10260 is a standard-length (verify from order — often 3 m / 6 m / 9 m selectable via suffix not shown here) shielded cable with Intercontec motor-side connector and drive-side flying leads or D-sub/M12 as applicable.
Product Introduction: TPAR prefix in Kollmorgen legacy catalogs refers to tachometer/generator or resolver-to-encoder adapter components used with Goldline motors. "3330-56" specifies the tach generator type (3300 series — 30 V/krpm typical) or cable/adapter part number. Often a separately-mounted DC tach or an adapter box for resolver-to-drive interfacing.
Product Introduction: The KC1 (Kollmorgen Control — 1st generation integrated PAC + drive) combined a KAS (Kollmorgen Automation Suite) programmable automation controller with an AKD-class servo drive on one module. "B00306" = 3 A continuous drive section; "NCC" = no fieldbus option card / standard I/O + CANopen or serial. This unit runs IEC 61131-3programs and controls one axis locally while communicating with upstream HMI/PLC.
Product Introduction: The DH062 is a framed (housed) direct-drive rotary motor that couples directly to the load — eliminating gearboxes, belts, and couplings. The "M" denotes single-bearing housed version; "-22" typically indicates 220 V winding or specific stack/feedback config; "-1" = standard option set. Provides zero backlash, high stiffness, and exceptional repeatability
Product Introduction: This is a Kollmorgen-specified external braking resistor used to dissipate regenerative energy from decelerating servo motors when the DC bus voltage would otherwise rise to a fault level. The MTB prefix designates Motion Technology Brake resistor; "706" relates to AKD 6/12 A frame compatibility; "SB2" = Standard Brake Resistor, 2nd variant; H191-022 = resistance/power/cable configuration per Kollmorgen ordering system.
Product Introduction: The AKM33C is a medium-frame (Size 33 = 70 mm square flange) permanent-magnet synchronous servomotor from Kollmorgen's AKM family. "ANCNR-00" decodes approximately as: A=AKM series, N=Standard winding (640 VDC bus max for C-winding), C=Connector (Intercontec), N=No brake, R=Resolver feedback (typical for -NR suffix), 00=Standard seal/shaft.
Product Introduction: The AKD-B series is a standard-performance single-axis servo drive from Kollmorgen's AKD platform. It provides plug-and-play commissioning with Kollmorgen AKM servomotors and features Ethernet-based setup via Kollmorgen WorkBench software. The "B" denotes the base drive version without fieldbus; "N" = no options; "BE" typically indicates built-in EtherCAT option in some regional catalogs, but this unit is primarily analog/serial command capable.
Product Brief: Compact high-torque-density PMSM servo motor, frame 22 (70 × 70 mm IEC flange — NEMA 34 mini), E-winding = medium stack for AKM22 (continuous stall torque ~1.27 Nm). Factory-fitted with EnDat 2.1/2.2 absolute multiturn encoder ("EN" = EnDat in AKM2x code — "ENB2" = EnDat, B = keyed shaft, 2 = IP65 seals, DB0 = brake + connector config), keyed shaft, 24 VDC spring-applied holding brake ("DB" or "B" in brake position), rotatable M23 connectors (separate power+brake and feedback). Auto-recognizable by AKD/S700 drives via motor ID resistor network.
