Technical Specifications:

• Controller Type: Single-loop PID controller
• Input Type: Universal (TC Type J, K, T, E, B, R, S, L, N, W / RTD Pt100, JPt100, Cu50 / DC Voltage 0–5V, 1–5V, 0–10V / DC Current 4–20mA, 0–20mA / Frequency 0–1kHz)
• Control Output: Relay output (2 SPDT relays) + 4–20mA DC output (optional)
• Alarm Output: 2 alarm outputs (HIGH, LOW, DEVIATION, BAND)
• Display: 5-digit, 7-segment red LED (main value) + 4-digit green LED (setpoint)
• Control Modes: PID, ON/OFF, 2-Position, Heating/Cooling PID
• Scan Rate: 250 ms (0.25 second)
• Power Supply: 100–240 VAC, 50/60 Hz / 24 VDC (dual supply capable)
• Power Consumption: Maximum 5 VA
• Operating Temperature: -10 to +55 °C (14 to 131 °F)
• Protection Rating: Front panel IP66 / NEMA4X
• Dimensions: 48 mm (W) × 96 mm (H) × 106 mm (D) (1/4 DIN: 45 × 90 mm cutout)
• Weight: Approximately 0.35 kg

Functional Features:

• Auto-tuning function (relay method + PID method) for rapid commissioning
• Built-in 32 segment program pattern for ramp/soak control
• SV ramp function (soft start/stop for setpoint changes)
• Manual/Auto/Cascade control modes
• Heating/Cooling control with differential gap
• Remote setpoint input (analog or digital)
• Communication: RS-485 (Modbus RTU) — optional module

Performance Parameters:

• Control Accuracy (PID): ±0.2% of full scale (F.S.) or ±1 digit (whichever is greater)
• Repeatability: ±0.1% of F.S.
• Alarm Accuracy: ±0.5% of F.S.
• Output Accuracy (4–20mA): ±0.2% of span

Structural Features:

• Housing: Flame-retardant polycarbonate front, ABS rear housing (UL94 V-0)
• Terminal Block: Screw terminal, wire size 0.5–2.5 mm² (AWG 20–14)
• Mounting: 1/4 DIN panel clip or DIN rail (35 mm)
• Front Panel: Snap-on, gasket-sealed for IP66 protection

Applicable Industries:

• HVAC — Temperature control in air handling units
• Food Processing — Oven and fryer temperature control
• Plastics & Rubber — Extruder and mold temperature control
• Water Treatment — Tank level and temperature control
• General Manufacturing — OEM machine integration

Installation Requirements:

• Panel cutout: 45 mm (W) × 90 mm (H) for 1/4 DIN mounting
• Use shielded cable for all input signals
• Ground the shield at one end only (controller end recommended)
• For TC inputs, use correct thermocouple extension wire type matching the TC type
• For RTD inputs, use 3-wire configuration for best accuracy

Precautions:

• Do not apply voltage exceeding 30 VDC or 250 VAC between terminals
• Ensure input signal does not exceed rated input range (overrange will cause inaccurate reading)
• Do not disassemble the front panel — IP66 seal will be voided
• Allow 30 minutes warm-up after power-on for stable readings