Digital guide
You are here:
Honeywell 51401286-100
- Product Name: 16-Channel High-Level Analog Input Module (EPDG Interface / High-Density AI Card)
- Product Introduction: A high-density analog input card developed for Honeywell TDC3000 and Experion PKS distributed control systems. It is equipped with 16 universal analog input channels compatible with 4–20 mA transmitters, 0–5 V / 1–5 V / 0.4–2 V analog signals, and supports HART communication for intelligent field instruments.
Detailed content
- Technical Specifications:
- Channels: 16 analog inputs (12 single-ended + 4 differential)
- Supported Signals: 4–20 mA, 0–5 V, 1–5 V, 0.4–2 V
- Communication: HART protocol compatible
- A/D Resolution: 16-bit high precision
- CMRR: ≥ 70 dB (anti-interference)
- Auxiliary Power: 24 VDC rack power supply
- Operating Temperature: -20 °C to +60 °C
- Humidity: 5 %–95 % non-condensing
- Construction: Conformal-coated PCB
- Weight: ~0.72 kg
- Compatible Systems: Honeywell TDC3000, Experion PKS control chassis
- Functional Features: High-precision 16-bit A/D conversion with high common-mode rejection to suppress EMI from long-distance wiring. Full-channel self-diagnosis detects wire break, short circuit, and sensor faults. Front-panel LED status indicators enable quick on-site inspection. Standard single-slot rack plug-in design.
- Application Scenarios: Critical replacement spare for power plants, refineries, chemical and oil & gas process control racks. Used in process industries for precise analog signal acquisition.
- Structural & Material Characteristics: Single-slot rack plug-in design. Conformal-coated circuit board for harsh environments. Industrial-grade components.
- Working Principle: Each channel conditions the incoming analog signal (current or voltage), converts it via 16-bit ADC, and transmits digital data over the Honeywell backplane bus. Differential channels provide enhanced noise immunity for long cable runs.
- Installation Requirements: Insert into a standard Honeywell TDC3000 / Experion PKS rack slot. Install in a control cabinet with adequate ventilation and protection rating of IP30 or higher. Keep analog signal wiring separated from power cables by at least 15 cm.
- Usage Notes: Use shielded cable for all analog inputs. Tighten terminal screws, especially in vibration-prone areas. Perform firmware updates via Honeywell configuration software with prior program backup. Inspect wiring and terminal cleanliness semi-annually.
