Technical Specifications:

• Output Voltage: 24 V DC (adjustable ±5%)
• Output Current: 10.0 A (continuous)
• Output Power: 240 W (maximum)
• Input Voltage Range: 100 V AC to 240 V AC (single-phase, 50/60 Hz)
• Input Frequency: 50 Hz / 60 Hz (auto-sensing)
• Efficiency: Greater than 90% (at full load)
• Output Ripple: Less than 100 mV peak-to-peak
• Output Noise: Less than 50 mV RMS
• Protection Features: Short-circuit protection, overcurrent protection, overvoltage protection, overtemperature protection, no-load protection
• DC OK Relay: 1 × changeover contact, 250 V AC / 3 A
• Protection Rating: IP20
• Operating Temperature: 0 °C to +50 °C (derating above +40 °C)
• Storage Temperature: -25 °C to +70 °C
• MTBF: Greater than 100,000 hours (at 25 °C)
• Dimensions (W × H × D): Approximately 75 mm × 120 mm × 100 mm
• Weight: Approximately 0.85 kg
• Mounting: DIN rail TS 35
• Safety Certifications: CE, UL, cUL, CCC

Functional Features:

• Universal AC input (100–240 V AC)
• 10 A continuous output — supports large X20 I/O configurations
• DC OK relay for system fault monitoring
• LED power status indicator (green = OK, red = fault)
• High efficiency (>90%) minimizes heat generation
• Conformal coated PCB for industrial environment durability

Applicable Industries:
Large-scale machine building, packaging lines, process plants, automotive, semiconductor, food and beverage, pharmaceutical, water treatment.

Installation Requirements:

• Mount on DIN rail TS 35
• AC input wiring: L, N, PE — wire size minimum 2.5 mm² (for 10 A output capability)
• DC output wiring: +V, -V — wire size minimum 4 mm² (for 10 A)
• DC OK relay: wire to PLC digital input for fault monitoring
• Maintain minimum 15 mm clearance on all sides for ventilation (higher power = more heat)
• Forced-air cooling recommended in enclosed cabinets above +40 °C

Usage Notes:

• Derate output current by 2.5% per °C above +40 °C ambient
• Protective earth (PE) connection is mandatory at all times
• Do not exceed 240 W total load on output terminals
• DC OK relay status must be part of safety or fault-handling logic in the PLC program
• Use torque-controlled screw terminals per manufacturer specification (typically 0.8 Nm)