Technical Specifications:

• Number of Channels: 24 digital outputs
• Output Type: Transistor (NPN/PNP selectable)
• Output Voltage: 24 V DC nominal
• Maximum Load Current per Channel: 0.5 A
• Total Module Current: 8 A maximum
• Isolation Voltage: 500 V DC between channels and backplane
• Response Time: < 1 ms per channel
• Operating Temperature: -25°C to +70°C
• Protection Rating: IP20 (DIN rail mountable)
• Supply Voltage: 24 V DC ± 20%
• Dimensions (W x H x D): 120 mm x 90 mm x 65 mm
• Weight: Approximately 280 g

Structural Features:

• DIN rail mounting (EN 50022 standard, 35 mm rail)
• Spring-loaded terminal blocks for wire connection
• LED status indicators per channel group (8 groups of 3)
• Modular front-loading design for hot-swap capability
• Plastic housing made from flame-retardant polycarbonate (UL94 V-0)

Working Principle:
The module receives digital control signals from the PLC via a backplane bus. Each output channel uses a photocoupler-isolated transistor driver to switch the load. The NPN/PNP configuration is set via DIP switches on the module front.

Key Advantages:

• High channel density (24 outputs in compact form factor)
• Galvanic isolation on every channel for noise immunity
• Hot-swap capable without system shutdown
• Diagnostic LEDs for rapid fault identification

Applicable Industries:
Manufacturing automation, packaging machinery, water/wastewater treatment, HVAC control, material handling systems.

Installation Requirements:

• Mount on 35 mm DIN rail (EN 50022)
• Ensure adequate ventilation (minimum 10 mm clearance above and below)
• Use shielded cables for output wiring in high-EMI environments
• Torque terminal screws to 0.5 Nm

Usage Precautions:

• Do not exceed 0.5 A per channel or 8 A total module current
• Verify NPN vs PNP wiring before energizing
• Do not connect inductive loads without flyback diodes
• Maintain operating temperature within -25°C to +70°C