Technical Specifications:

• Cooling Capacity: 2.5 kW (8,500 BTU/h)
• Heating Capacity: 2.7 kW (9,200 BTU/h)
• Energy Efficiency Ratio (SEER): 6.1 (A++)
• Energy Efficiency Ratio (SCOP): 4.0 (A+)
• Refrigerant Type: R32 (Eco-friendly, low GWP)
• Indoor Noise Level: 22 dB(A) (low) to 37 dB(A) (high)
• Airflow Rate: 580 m³/h
• Dehumidification Capacity: 1.2 L/h
• Voltage / Frequency: 220-240V / 50Hz
• Indoor Unit Power Consumption (Cooling): 730W
• Indoor Unit Power Consumption (Heating): 780W

Dimensions (W x D x H): 845 x 290 x 189 mm

Weight (Indoor Unit): 10.5 kg

Material Composition:

• Casing: High-impact ABS plastic, white matte finish
• Heat Exchanger: Copper tube with aluminum fins
• Air Filter: Washable nylon mesh + antibacterial coating
• Louvers: ABS plastic with motorized swing

Structural Features:

• IFeel remote sensor — measures temperature at user location, not just at unit
• 7-day programmable timer
• Sleep mode — gradually adjusts temperature ±1°C per hour
• Turbo mode — rapid cooling/heating in 30 seconds
• Auto-restart after power failure
• Self-diagnosis display — error codes shown on LED panel
• Gold fin anti-corrosion coating on heat exchanger

Working Principle:
DC inverter compressor modulates speed continuously (not on/off cycling) to match cooling/heating demand precisely. R32 refrigerant circulates through the indoor coil, absorbing heat from room air (cooling) or releasing heat (heating). The IFeel sensor communicates wirelessly with the remote to adjust compressor speed based on actual occupant-zone temperature.

Key Advantages:

• A++ SEER 6.1 — among the highest efficiency in class
• R32 refrigerant — 67% lower GWP than R410A
• IFeel smart sensor — eliminates hot/cold spots
• Ultra-quiet at 22 dB(A) — whisper-level operation
• Inverter technology — 30-40% energy savings vs. fixed-speed
• Self-diagnosis for easy troubleshooting

Applicable Industries / Use Cases:
Residential bedrooms, living rooms, small offices, hotels, apartments

Installation Requirements:

• Must be paired with matching AEG outdoor unit (AS-B885-001 or compatible)
• Wall must support minimum 20 kg load (unit + bracket)
• Pipe run length: max 15m (max height difference 10m)
• Requires 16A dedicated circuit with earth leakage protection
• Condensate drain must slope downward at minimum 1% gradient
• Vacuum pump evacuation mandatory during installation (min 30 min)

Usage Precautions:

• Clean air filters every 2 weeks during heavy use
• Do not operate below -15°C ambient in heating mode (unless rated)
• Use only R32 refrigerant — do not mix with other refrigerants
• Ensure outdoor unit has clear airflow (min 30cm on all sides)
• Schedule professional servicing annually