Technical Specifications:

• Material: 6063-T5 Aluminum Alloy
• Thickness: 1.5mm ± 0.1mm
• Surface Treatment: Anodized, clear satin finish (Ra 0.4–0.8 μm)
• Dimensions: Approximately 596mm (W) × 818mm (H) × 25mm (D) — varies by appliance model
• Weight: 2.8–3.5 kg (depending on exact dimensions)
• Color: Silver anodized (RAL 9006 equivalent) / optionally available in anthracite
• Hardness: 80–95 HB (Brinell)
• Corrosion Resistance: Salt spray test ≥ 500 hours (ISO 9227)

Material Composition:

• Base Metal: 6063-T5 aluminum (Al-Mg-Si alloy)
• Anodized Layer: 12–18 μm thick hardcoat anodic oxidation
• Sealant: Hot water sealed pores for maximum corrosion resistance
• Mounting Hardware: Stainless steel A2 screws (included)
• Gasket Interface: EPDM rubber seal channel (integrated or separate)

Structural Features:

• CNC-machined mounting holes with ±0.1mm positional tolerance
• Integrated handle recess for flush-mount grip design
• Inner reinforcement ribs for rigidity (stamped from same sheet)
• Edge profile: rounded 2mm radius for safety and aesthetics
• Compatible with AEG click-in mounting rail system

Working Principle: Serves as the visible exterior fascia of the built-in appliance, providing structural protection to the door assembly while delivering a premium aesthetic finish. The anodized surface provides a hard, wear-resistant, and corrosion-proof exterior that maintains appearance over the appliance lifetime.

Advantages:

• Premium aesthetic matching AEG designer appliance lines
• Anodized finish resists fingerprints, scratches, and UV discoloration
• Lightweight — 60% lighter than equivalent stainless steel panel
• Fully recyclable aluminum — 100% recyclable at end of life

Applicable Industries: AEG built-in ovens, AEG built-in dishwashers, AEG built-in washing machines, AEG built-in refrigerators

Installation Requirements:

• Align with appliance mounting rail using provided template
• Secure with 4× M4 stainless steel screws (torque: 2.5 Nm)
• EPDM gasket must be seated evenly around full perimeter
• Ensure panel is level (±1mm tolerance) before final tightening

Usage Precautions:

• Clean with soft damp cloth only — do not use abrasive cleaners or steel wool
• Do not apply excessive force on handle recess area
• If anodized coating is damaged, apply AEG touch-up anodizing pen to prevent corrosion