Digital guide
You are here:
AEG 6051-042.23602
Product Name: AEG 6051-042.23602 Drain Pump Motor Assembly
Product Category: Pump Motor / Drainage Pump Component
Model Series: 6051 Series OEM Pump
Overview: The AEG 6051-042.23602 is an original drain pump motor assembly used in AEG washing machines, washer-dryer combos, and dishwashers. It is responsible for pumping out wash water, rinse water, and drained condensate from the appliance.
Detailed content
Key Specifications:
| Parameter | Value |
|---|---|
| Part Number | 6051-042.23602 |
| Motor Type | Single-Phase Asynchronous (Induction) Motor |
| Rated Voltage | 220–240 V AC / 50 Hz |
| Rated Power | 25 W – 40 W (depending on application) |
| Rated Speed | 2,800 – 3,200 RPM |
| Max Flow Rate | 1.2 L/min (at zero head) |
| Max Head Pressure | 0.8 – 1.2 m (80–120 cm) |
| Hose Connection | 18–22 mm internal diameter (barbed fitting) |
| Noise Level | ≤ 55 dB(A) |
| Protection Class | IPX4 (splash-proof) |
| Insulation Class | Class B (130°C) |
| Bearing Type | Sleeve bearing (oil-lubricated, maintenance-free) |
| Dimensions | Approximately 100 × 80 × 95 mm (L×W×H) |
| Weight | Approximately 0.65 kg |
| Cable Length | 900 mm with molded connector |
Material Composition:
- Housing: Polypropylene (PP) + glass fiber reinforced (30% GF)
- Impeller: Polypropylene (PP) — corrosion-resistant
- Motor Stator: Laminated silicon steel with copper windings
- Shaft: Stainless steel AISI 304
- Seal: EPDM rubber mechanical seal
Compatible Models: AEG L6FBG842, L7FBG842, L8FBG842 washing machines; AEG FSB52637P dishwashers; AEG DEA156, DEA180 dehumidifiers (condensate drain variant).
Functional Features:
- Auto-primes within 3 seconds of activation
- Self-cleaning impeller design reduces clog risk
- Thermal overload protection with auto-reset
- Anti-vibration rubber mounting feet
Installation Requirement:
- Disconnect power and water supply before replacement.
- Mount using 4 M5 screws with rubber grommets — torque to 2.5 Nm.
- Ensure drain hose is sloped downward at minimum 1 cm per meter.
- Prime pump with 200ml water before first cycle if dry.
Usage Notes:
- Check impeller monthly for coin, button, or fiber blockage.
- Do not run pump dry — causes bearing seizure within 30 seconds.
- Replace pump if noise exceeds 55 dB(A) — indicates bearing wear.
- Use only original AEG pump — third-party pumps have incompatible impeller geometry and cause error codes.
