Digital guide
You are here:
Kollmorgen SE55000-0000
Product Introduction:
The SE55000-0000 is a member of the Kollmorgen Seidel SERVOSTAR SE family, an early-generation digital servo drive for brushless motors. It provides torque, speed and position control via resolver or encoder feedback. Now obsolete but widely used in retrofit of late-1990s machine tools.
Detailed content
Technical Specifications:
-
Input: 3 × 400 VAC ±10%, 50/60 Hz
-
Continuous current: 25 A (depending on firmware)
-
Peak current: 50 A for 2 s
-
Feedback: resolver, incremental encoder
-
Control modes: torque, speed, position (step/dir or ±10 V)
-
Communication: RS232 config port, optional DeviceNet/Profibus
-
Switching: 8 kHz PWM
-
Mounting: panel, 19-inch rack width
Features:
-
Fully digital DSP control
-
Auto-commissioning of motor parameters
-
Integrated brake chopper output
-
LED status + 7-seg diagnostic
Working Principle:
AC mains rectified to DC bus, IGBT bridge synthesizes sinusoidal current. DSP executes PI current loop at 8 kHz, outer speed/position loop at 1–2 kHz.
Materials & Construction:
-
Sheet-steel chassis, molded heat sink
-
Conformal-coated PCBs
Installation Requirements:
-
200 mm clearance above/below for convection
-
Separate PE ground, 4 mm² minimum
-
Motor cable < 25 m unshielded / < 50 m shielded
Precautions:
-
Not RoHS; capacitors age after 15 years—reform before power-up
-
Disable outputs before connecting resolver
-
Set motor ID manually if plug-and-play fails
