Digital guide
You are here:
KOLLMORGEN CR10251
Product Brief: These are pre-assembled, shielded motor interface cables used to connect Kollmorgen servo motors (typically Goldline B/H/T or early AKM) to ServoStar drives. CR-prefixed parts are generally feedback/encoder cables (resolver or sincos encoder to drive); CB-prefixed parts are generally motor power/brake cables (U/V/W + PE + brake wires if fitted). Exact pinout and length depend on suffix which is not fully shown here.
Detailed content
CR10251 — Typical Characteristics (Feedback Cable):
-
Shielded twisted-pair wires for encoder/resolver signals
-
Usually terminates in Intercontec or circular military-style connector at motor end, D-sub or terminal block at drive end
-
Length determined by suffix (not visible; standard lengths 3 m / 5 m / 10 m etc.)
-
Rated for 200+ V signal, suitable for Hiperface / EnDat / Resolver
CB06251 — Typical Characteristics (Motor Power Cable):
-
3 × power conductors + shield + (optional 2 × brake conductors if motor has brake)
-
Oil-resistant PUR or PVC jacket, highly flexible for drag-chain use
-
Intercontec power connector (threaded ring lock) at motor side; ferrule/stripped/tongue at drive side
-
Temperature rating -25 °C … +80 °C (flexing), -40 °C … +90 °C (static)
Installation Notes:
-
Route power and feedback cables in separate trays or with minimum 100 mm separation.
-
Connect shield to ground at drive end (and sometimes motor end) per installation manual.
-
Do NOT mix brake wires with signal pairs; verify brake voltage polarity separately.
