Connector Style:​ M23/M8 rotatable IP65 backshell when used as motor cable; braided shield with twisted pairs for feedback

Rating:​ Matched to 320 VDC-class AKM motors and AKD/S700 drives; conductor section set by current rating of connected axis

Construction:​ PVC/PUR jacket, foil+braid shielded, color-coded cores, strain relief boots

Mounting:​ Cable clamp to drag-chain or fixed tray; shield terminated to drive PE plate, not to signal ground

Applications:​ Wiring between PC800/AKD/S700 drive and AKM/B-series motor, resolver or encoder signal transmission

Precautions:​ Do not mix power and feedback pairs in unshielded conduit; verify length suffix and connector gender against motor/drive; CR06703 alone is not a functioning actuator

PC833-001-T​ is a legacy PC800 drive; pairs with B-206-A-31​ via resolver interface or with AKM21/22​ via resolver/encoder card.

AKM21C​ and AKM22E​ share 58 mm flange but differ in stack length, torque, and shaft/feedback coding; mechanical interchange requires coupling and brake-check review.

B-206-A-31​ is obsolete Goldline; mechanical footprint not identical to AKM, adapter flange or coupling change required.

CR06703​ is a support part; ordering must reference the exact Kollmorgen cable drawing to confirm pinout and length.

Common installation rules:​ mount drives vertical on grounded panel, separate 24 VDC logic from motor power, shield servo cables to PE, set drive bus voltage to motor max (320 VDC for AKM21/22 and B-206-A), perform resolver/encoder offset calibration on every motor swap, never energize brake coil from unswitched mains.