Product Brief:​ Factory-molded shielded cable with motor-side circular connector (Intercontec M23 or Hirschmann-style) and drive-side flying leads or mating connectors for Kollmorgen SERVOSTAR CD/S300/S600/S700 drives. CR06660 typically denotes a servo motor feedback cable (resolver or encoder) or combined power+feedback cable​ for small-to-mid frame Goldline B/M-series or AKM2x–AKM4x motors (≤ 6 A class). Exact function (POWER vs FEEDBACK) must be verified from the cable tag — CR-series cables are often feedback-only for Goldline; power cables of same era are CB-prefix. If CR06660 is feedback: resolver (R1/R2 excitation + S1/S2/S3/S4) or encoder (A/A– B/B– Z/Z– + 5 V/GND + thermistor) in shielded twisted pairs.

Cable Type (if Feedback — typical CR):​ Twisted-pair screened wires AWG 24–AWG 22​ — resolver: R1/R2 excitation + S1/S2/S3/S4 sine/cosine; encoder: A/A– B/B– Z/Z– + 5 V/GND + motor thermistor

Cable Type (if Power — less common for CR-prefix):​ 4× power conductors AWG 18–AWG 16​ (≤ 6 A), brake pair AWG 22

Shielding:​ Overall tinned copper braid + AL-foil, drain wire terminated at drive-end connector shell

Jacket Material:​ PUR (Polyurethane)​ — oil-resistant, flame-retardant per UL 20276/ IEC 60332-1; halogen-free option on some revisions

Rated Voltage:​ Power cores ≤ 600 V AC/DC; Signal cores ≤ 30 V DC

Temperature Range (Operation):​ –25 °C to +80 °C​ (PUR jacket)

Bend Radius (Static):​ ≥ 5 × OD; (Flex/Trailing Chain) ≥ 10 × OD

Connector (Motor End):​ M23 / Interconteccircular, keyed, rotatable, IP65 when mated

Connector (Drive End):​ Flying leads with ferrules OR pre-installed terminal-block plug / SUB-D (feedback) per SERVOSTAR I/O layout

Length:​ Defined by last digits of full order code (common: 3 m / 5 m / 7 m — CR06660 often = 3 m feedback cable)

Compliance:​ CE, ULrecognized component, RoHS, DESINA color coding (where applicable)

Applicable Industries:​ Legacy Goldline B/M-series & early AKM equipped packaging, converting, printing, textile retrofits

Installation Requirements (Cable):​ Route power and feedback cables separately from high-voltage mains (≥ 200 mm separation or partitioned duct); bond shield to drive chassis ground terminal only at one end (drive side); verify connector keyway before mating; avoid tight bend radii < 5× OD.

Usage Notes:​ Inspect O-ring on motor connector before mating to maintain IP65; if CR06660 is feedback cable — pair with a CB-prefix power cable of matching length for non-hybrid installations; if AKM motors with single-cable SFD3/Hiperface DSL use CE/CP hybrid cables instead.