Technical Specifications:

• Series: AKM
• Frame Size: 52 mm (stator diameter)
• Motor Length: E (standard length)
• Winding Code: T
• Feedback Type: Single-turn absolute — EnDat 2.2
• Rated Torque: 0.65 Nm (continuous)
• Peak Torque: 1.95 Nm
• Rated Speed: 3000 RPM
• Max Speed: 6000 RPM
• Rated Voltage: 48 VDC (nominal DC bus)
• Phase Resistance: 3.8 Ω (typical)
• Phase Inductance: 6.2 mH (typical)
• Insulation Class: Class F (155°C)
• Protection Rating: IP69K (housing), IP67 (connector)
• Shaft Type: Keyed shaft with flat, stainless steel
• Connector: M23, 12-pin, stainless steel
• Housing Material: 316L Stainless Steel
• Weight: Approximately 0.8 kg

Key Features:

• IP69K rated — withstands high-pressure (80 bar), high-temperature (80°C) washdown
• 316L stainless steel housing — corrosion resistant
• EnDat 2.2 absolute encoder — no homing required
• Smooth surface finish — Ra ≤ 0.8 µm for hygienic compliance
• No paint or coating — eliminates flaking and contamination risk

Material Composition:

• Stator: Silicon steel laminations with epoxy coating
• Rotor: Neodymium (NdFeB) permanent magnets with nickel-copper-nickel plating
• Housing: 316L Stainless Steel (electropolished)
• Shaft: 17-4 PH Stainless Steel
• Bearings: Stainless steel sealed ball bearings (lubricated with food-grade grease)
• Seals: FDA-compliant fluorocarbon (Viton) O-rings

Applicable Industries:
Food and beverage processing, pharmaceutical manufacturing, dairy, brewing, cleanroom automation, medical device manufacturing.

Installation Requirements:

• Use only stainless steel fasteners (316L grade)
• Apply food-grade lubricant on shaft and coupling
• Verify connector seal integrity before each washdown cycle

Usage Notes:

• Maximum ambient temperature: 40°C (derate torque by 2% per °C above 40°C)
• Do not use abrasive cleaning agents on the housing
• Perform insulation resistance test (> 100 MΩ at 500 VDC) quarterly