Digital guide
You are here:
GE DS3820HI0B
Product Name: GE Fanuc DS3820HI0B High-Density Analog Input I/O Module
Product Introduction: A high-density analog input module for GE Fanuc Mark V / Mark VI turbine control systems, used for monitoring temperature, pressure, flow, and level signals in power generation and process control applications.
Detailed content
Technical Specifications:
- Channels: 20 analog input channels
- Signal Types: 4–20 mA (2-wire / 3-wire) or 0–10 VDC
- Resolution: 16-bit A/D conversion
- Sampling Rate: 10 ms per channel (typical)
- Accuracy: ±0.1 % FS
- Input Impedance: 250 Ω (current mode) / 1 MΩ (voltage mode)
- Channel-to-Channel Isolation: 500 VDC
- CMRR: ≥ 120 dB @ 50 Hz
- Backplane Power: +5 VDC from system backplane
- Operating Temperature: –20 °C to +70 °C
Functional Features: High-density 20-channel design; independent per-channel isolation; open-wire detection; sensor fault diagnostics; configurable current/voltage modes via jumper or software.
Material & Construction: FR-4 glass-epoxy PCB with gold immersion finish; high-density D-sub connector with gold-plated contacts; die-cast aluminum alloy housing with anodized treatment; isolation achieved via precision isolation amplifier ICs + optocouplers.
Working Principle: Field analog signals pass through front-end signal conditioning (filtering, clamping, isolation) into a 16-bit A/D converter; converted results are transmitted over the backplane bus in serial format to the controller CPU.
Application Scenarios: Gas turbine & steam turbine control systems, petrochemical process control, water treatment, paper & pulp, metallurgy.
Installation & Usage Notes: Install in designated slot of GE Fanuc Mark V / Mark VI I/O cabinet; never hot-swap while energized; use shielded twisted-pair for analog wiring with shield grounded at a single point; maintain ≥ 200 mm separation from power cables; input signals must not exceed 30 VDC or 25 mA. Calibrate all channels annually.
