Digital guide
You are here:
GE DS3815CCMD1B1B
Product Introduction: The DS3815CCMD1B1B is a circuit-board module within GE’s Speedtronic drive and turbine control product family. Based on its DS3815 prefix it belongs to GE’s Mark VI/Mark VIe control I/O series, used for data exchange and status monitoring between the control system and host computers, DCS, or other control systems. Publicly available detailed official datasheets for this exact part number are limited; the following parameters are compiled from industrial supplier documentation and should be confirmed against GE’s original drawings or the nameplate before deployment.
Detailed content
Technical Specifications:
-
Module Type: Communication & monitoring module (circuit board)
-
Communication Interfaces: Ethernet (10/100 Base-T) + serial (RS-232/RS-485)
-
Ethernet Protocols: TCP/IP, Modbus TCP, GE SRTP, SNMP
-
Communication Rate: 10/100 Mbps auto-negotiation
-
Backplane Power: 5 V DC
-
Power Consumption: ≤ 5 W
-
Operating Temperature: 0 °C to +60 °C
-
LED Indicators: PWR (power), RUN (running), COMM (communication), FLT (fault)
-
Mounting: Insert into standard Mark VIe cabinet backplane slot
Functional Features:
-
Dual communication channels with MRP redundancy protocol support to improve link reliability
-
Real-time system health monitoring and module status reporting
-
Remote firmware upgrade capability
-
Event log upload and alarm management
-
Integration with OPC UA / OPC DA interfaces via host software
Application Scenarios: Gas turbine power plants, combined-cycle power plants, oil & gas pipeline SCADA, and industrial process control systems.
Installation Requirements: Insert into the GE Mark VIe cabinet standard backplane slot. Use Cat5e or higher shielded Ethernet cables. IP addresses must be uniquely assigned within the system configuration.
Usage Notes: Replace the module only when the system is shut down. Confirm the exact functional revision with GE or an authorized distributor, as DS3815-series boards may be configured for different roles (communication, analog I/O, power control, etc.).
