Digital guide
You are here:
GE DS215UCIBG3A
Product Introduction
The GE DS215UCIBG3A is a central processing and interface motherboard developed by General Electric for the Mark V Speedtronic turbine control platform. It acts as the primary computational hub in both Simplex and Triple Modular Redundant (TMR) gas turbine and steam turbine control architectures, coordinating data exchange between the host CPU, flash storage, Genius I/O network, and auxiliary control boards.
Detailed content
Technical Specifications
-
Operating Temperature: -22 °F to +150 °F (-30 °C to +65 °C)
-
Storage Temperature: -40 °F to +185 °F (-40 °C to +85 °C)
-
Relative Humidity: 95 % non-condensing
-
Power Consumption: 10.5 W typical, 4.6 W maximum idle
-
Communication Ports: RS-422, USB-B, dual Genius serial (P5/P6), COM ports (P10/P11)
-
Onboard Microprocessors: 196 discrete processor chips
-
Mass: 0.82 kg
Functional Features
-
Executes turbine sequencing, speed/load control, and DLE gas fuel pressure conversion from TCSA board data
-
Hosts two uGENI communication daughterboards and one IDE flash disk
-
Supports automatic TMR controller synchronization
-
Provides front-panel and onboard LED status indication for alarm and health monitoring
Material Composition
-
Multilayer FR-4 glass-epoxy printed circuit board
-
Surface-mounted resistors, resistor arrays, diodes, capacitors
-
Gold-plated edge connectors and drilled corner mounting holes
Structural Characteristics
-
Rectangular board with factory-drilled alignment holes at all corners
-
Male headers J1–J4 for LBC-586, PANA board, and IDE flash drive
-
Female connectors P5, P6 (Genius serial), P8, P9, P15, P16 (power), P10, P11 (COM)
-
Conformal coating for humidity and contamination resistance
Working Principle
Field and board-level data are received from TCSA and Genius I/O, processed by the onboard microprocessor array, voted in TMR mode, and pushed to actuator drives and HMI over Genius serial or RS-422 links.
Application Scenarios
-
GE Frame 5/6/7 gas turbines
-
Steam turbine electro-hydraulic control (EHC)
-
Combined-cycle power plants, refinery cogeneration units
Installation Requirements
-
Mount in Mark V VME-style card rack with correct guide-rail alignment
-
Use anti-static wrist strap; board is ESD-sensitive
-
Verify power connector seating on P8/P9/P15/P16 before rack energization
Usage Precautions
-
Do not hot-insert into live backplane
-
Keep flash disk firmware matched to Mark V TMR revision
-
Inspect edge connectors for oxidation during planned outages
