Digital guide
You are here:
Applied Materials 0010-23716
Product Name
Semiconductor Equipment Power Supply Module, public alternate listing as Signal Conditioning or Control Module.
Product Introduction
Public supplier data lists this number for Applied Materials semiconductor tools in two ways: a 24 V DC power supply/spare module and an analog signal conditioning/control module. Confirm the exact variant from the equipment bill of materials or original nameplate.
Detailed content
Technical Specifications
Power supply variant: input 100 to 240 V AC, 50/60 Hz; output 24 V DC; listed output 50 W in one source and 20 A in another source, so verify rated current from the original module label.
Output accuracy: plus/minus 1 percent in the 50 W listing.
Signal conditioning variant: 24 V DC supply, plus/minus 15 percent; input 4 to 20 mA and plus/minus 10 V DC; isolated output 4 to 20 mA and plus/minus 10 V DC.
Isolation: 2.5 kV AC galvanic isolation between input, output, and power in the signal variant.
Power consumption: up to 2 W in signal variant listings.
Operating temperature: 0 to 55°C in power listing, minus 20 to plus 60°C in signal listing.
Storage temperature: minus 20 to plus 85°C.
Ingress protection: IP20 in power listing.
Dimensions: approximately 120 by 80 by 40 mm in power listing; 125 by 80 by 40 mm in signal listing.
Functional Features
Power variant: stabilized 24 V DC for control boards, RF accessories, heaters, or instrument loads according to tool documentation.
Signal variant: analog conversion, isolation, linearization, and filtering between field instruments and controller.
Diagnostics: LED status in some listings; signal integrity and fault indication in signal variant descriptions.
Structural Characteristics
Enclosed industrial module with AC input terminals or DC terminals, output connectors, and mounting format defined by the tool chassis. Signal variant listings describe DIN rail mounting; power variant listings describe chassis or panel mounting depending on source.
Working Principle
Power variant rectifies and regulates AC input to controlled 24 V DC with overload protection. Signal variant amplifies, isolates, and conditions sensor current or voltage signals, then transmits standardized outputs to the process controller.
Application Scenarios
Etch and CVD chamber auxiliary power.
Mass flow, pressure, temperature, and heater signal interfacing.
Semiconductor fab control cabinets requiring isolated analog loops.
Spare replacement for AMAT tool power or signal subsystems.
Installation Requirements
Verify input voltage, output current, connector type, and firmware or configuration label.
De-energize the tool chassis before replacement.
For DIN mount signal modules, use 35 mm standard rail and proper grounding.
For AC power modules, torque terminals to manufacturer specification and check clearance.
Usage Precautions
Do not mix the 50 W power variant with the 20 A power variant without confirming original ratings.
Avoid operating above the listed temperature and ingress limits.
Check isolation and grounding in cleanroom electrical cabinets.
Validate output with dummy load or calibrated sensor before returning the tool to process control.
