Digital guide
You are here:
AEG MM-P10-200
Product Introduction:
The AEG MM-P10-200 is a single-phase pump motor module rated at 200W output, designed for circulator pumps in domestic hot water systems, underfloor heating circuits, and small HVAC applications. It integrates a capacitor-run induction motor with a thermal protection device.
Model Series: MM-P10 Series (Pump Motor Modules)
Detailed content
Technical Specifications:
- Rated Power (P2): 200 W
- Rated Voltage: 230V AC / 50 Hz
- Rated Current: 1.2 A (approx.)
- Speed: 2800 RPM (2-pole)
- Insulation Class: Class F (155°C)
- Protection Rating: IP44
- Capacitor: Permanent split capacitor (PSC), 4 µF / 450V AC
- Thermal Protection: Bimetallic thermostat (NC, 135°C trip)
- Mounting Type: Flange-mounted (B5) with 4-bolt pattern
- Shaft Diameter: 12 mm (DIN shaft with keyway)
- Housing Material: Aluminum alloy
- Weight: 3.8 kg
Functional Features:
- Permanent split capacitor (PSC) design for smooth, quiet operation
- Built-in thermal overload protector — auto-resets after cooldown
- Pre-lubricated bearings (lifetime lubrication, maintenance-free)
- Standardized mounting dimensions for direct pump coupling
Structural Characteristics:
- Cylindrical aluminum housing with integrated junction box
- Terminal box on top with cable gland entry (PG11)
- Ball bearings (deep groove, sealed)
- Drain plug at housing bottom for condensation
Working Principle:
Single-phase AC power energizes the main winding and auxiliary winding (via PSC capacitor), creating a rotating magnetic field in the stator. The rotor (squirrel cage type) follows this field, producing torque on the shaft. The thermal bimetallic protector opens the circuit if winding temperature exceeds 135°C.
Advantages & Highlights:
- Energy-efficient PSC design — no starting capacitor required
- Low noise level: ≤45 dB(A) at rated load
- Compact B5 flange mount — direct pump integration without adapter
- Wide voltage tolerance: ±10% of rated voltage
Applicable Industries:
- Domestic hot water recirculation
- Underfloor heating manifold pumps
- Boiler feed pumps (small systems)
- Solar thermal circulation
Installation Requirements:
- Mount horizontally with terminal box facing upward
- Align shaft precisely with pump impeller (max 0.1 mm offset)
- Use flexible coupling to absorb vibration
- Connect via 3-core cable (L, N, PE) with 1.5 mm² minimum cross-section
Usage Precautions:
- Do not operate with blocked pump outlet (dead-head condition > 30 seconds)
- Verify rotation direction before coupling to pump (clockwise viewed from shaft end)
- Ensure ambient temperature does not exceed 40°C
- Check insulation resistance (>5 MΩ) before first energization
