Technical Specifications:

• Sensor Type: NTC Thermistor (Negative Temperature Coefficient)
• Resistance at 25°C: 10 kΩ (±1% Tolerance)
• B-Constant (B25/85): 3950K (±1%)
• Operating Temperature Range: -40°C to +300°C
• Output Signal: 0.5V to 4.5V (Analog, Linearized)
• Accuracy: ±1°C at 150°C
• Response Time: < 5 seconds (t63)
• Connector: 2-Pin Molex / AEG Proprietary (Rated 250V / 3A)
• Board Dimensions: Approximately 40 mm x 25 mm

Functions:

• Cavity Temperature Measurement for PID Control Loop
• Over-Temperature Safety Cut-Off Trigger (Threshold: ~320°C)
• Defrost Cycle Temperature Monitoring
• Pyrolytic Cleaning Cycle Temperature Verification

Material Composition:

• Thermistor Element: Mn-Ni-Co Oxide Ceramic (Epoxy Encapsulated)
• PCB: FR-4 (Small Form Factor)
• Signal Conditioning IC: Operational Amplifier (LM358 or Equivalent)
• Protective Sheath: Stainless Steel 304 (Length: 80mm, Diameter: 6mm)

Applicable Industry: Residential Oven Manufacturing, Appliance Repair & Calibration

Installation Requirements:

• Must be inserted into designated sensor well in oven cavity
• Sensor tip must be flush with inner cavity wall
• Wire routing must avoid contact with heating elements

Usage Precautions:

• Do not bend the stainless steel sheath — minimum bend radius: 15mm
• Replace only with AEG-specified NTC thermistor (10kΩ / B3950)
• Calibrate against reference thermometer after replacement