Rated Voltage: 400 V AC (three-phase) or 230 V AC (single-phase) variant

Heating Element Material: Incoloy 800 (Ni-Fe-Cr alloy) sheath

Maximum Operating Temperature: 850°C (element surface)

Sheath Diameter: 8 mm (standard)

Sheath Length: 270 mm (active heating length: 200 mm)

Terminal Type: Ceramic insulated high-temperature terminals

Protection Class: IP54 (with terminal box); IP65 (with gland seal)

Insulation Resistance: ≥ 100 MΩ at 500 V DC

Dielectric Strength: 1500 V AC for 1 minute (no breakdown)

Ambient Temperature Range: -40°C to +80°C

Housing Material: Stainless Steel 316L (for corrosive environments)

Watt Density: 35 W/cm² (standard); 50 W/cm² (high-density option)

Key Features:

• Rapid heat-up time: reaches 80% of setpoint within 45 seconds
• Uniform heat distribution along full sheath length
• Resistant to oxidation and scaling at high temperatures
• Compatible with PID temperature controllers

Applicable Industries: Plastic injection molding, food processing, chemical processing, die casting, laboratory ovens, drying systems

Installation Requirements:

• Insert heater into thermowell or directly into process medium
• Ensure minimum immersion depth of 75 mm beyond active zone
• Use thermal paste or compound at contact surface for optimal heat transfer
• Wire gauge: minimum 2.5 mm² copper for 2.7 kW at 400 V

Usage Notes:

• Do not operate heater dry (without process medium) — causes element burnout
• Perform insulation resistance test every 6 months in continuous-duty applications
• Replace element if sheath shows discoloration or blistering