Technical Specifications:

• Sensor Type: NTC Thermistor (Negative Temperature Coefficient)
• Resistance at 25°C (R25): 10 kΩ (±1% Tolerance)
• B-Constant (B25/50): 3435K (±1%)
• B-Constant (B25/85): 3950K (±1%)
• Operating Temperature Range: -50°C to +350°C
• Maximum Continuous Temperature: 300°C
• Accuracy: ±0.5°C (Calibrated at 100°C, 200°C, 250°C)
• Response Time (t63): < 3 seconds in Air
• Resistance Tolerance at 250°C: 200Ω ± 2%
• Connector Type: 2-Pin AEG Proprietary (Rated 250V / 5A)
• Lead Wire Length: 250 mm (Silicone Insulated, 0.5mm²)
• Probe Length: 150 mm (Stainless Steel Sheath)
• Sheath Diameter: 5 mm
• Sheath Material: Stainless Steel 316L (Food-Grade, Corrosion Resistant)

Functions:

• Oven Cavity Temperature Feedback to PID Controller
• Surface Temperature Monitoring (Glass Door Safety)
• Over-Temperature Safety Cut-Off (Activates at ~340°C)
• Defrost Cycle Termination Signal
• Fan-Assisted Cooking Mode Regulation

Material Composition:

• Sensing Element: Manganese-Nickel-Cobalt Oxide Ceramic (Sintered)
• Encapsulation: Glass-Sealed Bead (Hermetic Seal)
• Sheath: AISI 316L Stainless Steel (Electropolished)
• Lead Wires: Silicone Insulated (180°C Rating), Tinned Copper
• Connector Pins: Brass (Gold Plated, 0.5μm Au over 2μm Ni)

Applicable Models: AEG A1482AES, AEG Competence Series Ovens, AEG Induction Cooktops

Installation Requirements:

• Insert probe into designated sensor port in oven cavity wall
• Ensure full insertion — probe tip must contact cavity wall
• Route wires away from heating elements and fan motor
• Secure with brass compression fitting (provided)

Usage Precautions:

• Do not use multimeter in resistance mode on live circuit — risk of damage to control board
• Replace only with AEG 120-082-005 or exact equivalent (10kΩ / B3950)
• After replacement, perform oven calibration via service menu
• Probe sheath must not be kinked — minimum bend radius: 20mm
• Shelf Life (Unused): 5 years from manufacture date (store at 15–25°C, <60% RH)